Its function is to hold the first plastic coat in order to hold the start of the printing steady, avoiding undesirable mistakes. 3DLAC is the perfect substitute for Kapton tape and other types of fixers due to cost-saving and its easy application. A light 3DLAC mist over the surface is enough to hold completely the first layer of plastic to the base. Thanks to the properties of 3DLAC, while the base is hot the extruded plastic is firmly stuck. Once the printed piece gets cold, it can be taken off smoothly and without damages.
3DLAC IS INTENDED FOR ALL TYPES OF MATERIALS.
HOW TO USE:
Spray 3DLAC on the printing base at around 20 cm. Make sure the temperature of the base is high, this way the working piece will remain compactly fixed without moving. Once the printing is finished, wait until the heating base is below 30ºC, the adhesion will be lighter and without tools (depending on the characteristics and dimensions of the piece) the piece can be removed gently and without damage.